Doctor blades R1

Blades thickness - from 0.08 mm to 0.50 mm.
Blades width - from 5 mm to 90 mm.
Steel hardness - 550-600 HV.
Doctor blades are made of microstructured steel with a high carbon content. They are designed for flexo and gravure printing. They are characterised by high wear resistance for short and medium runs.

Doctor blades R2

Blades thickness: from 0.15 mm to 0.20 mm.
Blades width - from 5 mm to 90 mm.
Steel hardness - 520-550 HV.
Doctor blades are made of high carbon steel. They are designed for flexographic printing. They have proven to be a good choice for short and medium runs.

Doctor blades R3

Blades thickness - from 0.15 mm to 0.20 mm.
Blades width - from 5 mm to 90 mm.
Steel hardness - 600 - 640 HV.
Doctor blades are made of high quality microstructured steel with a high service life for long-lasting operation. This material is the best choice for gravure printing, including with complex inks, as it has increased resistance to wear over long runs.

Doctor blades R3 SUN

Blades thickness - from 0.08 mm to 0.50 mm.
Blades widths - from 5 mm to 90 mm.
The blades are made of high quality microstructured steel with a special coating for long-lasting flexographic and gravure printing.
These blades provide for high print productivity and quality.

Stainless steel doctor blades

Blades thicknesses - from 0.10 mm to 0.30 mm.
Blades width - from 5 mm to 90 mm.
Doctor blades are made of high quality stainless steel, which is suitable for water-based inks, UV-cured inks and highly aggressive solvent-based inks due to its high corrosion resistance. The blades are designed for flexographic and gravure printing.

Ceramic-coated doctor blades LEOPRINT

Blade thicknesses - from 0.10 mm to 0.30 mm.
Blade widths - from 5 mm to 90 mm.
These blades provide for high quality and precision printing where particularly long runtimes are required. They are ideal for abrasive inks, cold seal adhesives, high viscosity inks and other special inks. The blades are designed for flexographic and gravure printing.

Plastic doctor blades

Blades thickness - from 0.20 mm to 1.1 mm.
Blades width - from 5 mm to 100 mm.
Material the blade is made of is polyester.
These blades are used in flexographic printing and are suitable for both narrow and wide format printing. They are used as an active blade (with sharpening) and a passive or counter blade (with a square edge). These blades ensure a long service life of the anilox and the doctor blade chamber endseals.

UHMW plastic doctor blade

Blades thickness - from 0,80 mm to 2,5 mm
Blades width - from 5 mm to 25 mm
Blade material - UHMW polyethylene.
Polyethylene UHMW doctor blade is the original ultra high molecular weight polyethylene doctor blade developed for reduce scoring and extended life. UHMW is most often used in corrugated and envelope pressrooms as both a metering and containment blade.
UHMW is a self-lubricating material which exhibits excellent wear and abrasion properties.
Suitable for all printing with lacquer, glue and very high acidity solvent-based inks.